Re: [microblaze-uclinux] uClinux boot problem

[Yasushi SHOJI <yashi@xxxxxxxxxxxxxxxxx>]

At Sat, 05 Jun 2004 22:16:26 +1000,
John Williams wrote:
[...]
> >>Calibrating delay loop...
> > 
> > 
> > I just tested suzaku with msrset/msrclr enabled, suzaku stopped the
> > same place. I haven't dig any deeper to see what's causing this.
> > obviously interrupt is not working as John said in the other mail.
> 
> Sorry for the obvious question - but have you enabled the new MSR 
> instructions in the hardware build (and platgen tweak) - as per below?

ok, that was it.  Thanks John.

Fabrice, how's yours?

regards,
--
            yashi
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@itee.uq.edu.au
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/