[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
AW: AW: [microblaze-uclinux] SMSC LAN91C111
Hi Yashi,
I aked you earlier about how you connected the SMSC ethernet MAC-PHY and you nicely told us that you use the sram controller. Could you provide us with a mhs snippet how you hooked up the signals and maybe give us a hint where potential pitfalls are?
Thanks in advance
Jan
> -----Ursprüngliche Nachricht-----
> Von: Schunke Jan-Hendrik [mailto:Schunke@shf-communication.de]
> Gesendet: Mittwoch, 24. März 2004 08:56
> An: microblaze-uclinux@itee.uq.edu.au
> Betreff: AW: AW: [microblaze-uclinux] SMSC LAN91C111
>
>
> Hi Yashi,
>
> Thanks for your information.
>
> > we just used xilinx's sram controller to connect it with
> > 16bit width bus. nothing fancy.
>
> I would probably have spent a lot of time writing my own
> core. Sometimes it is hard to see the obvious ;-)
>
> Do you plan to use the smsc on your suzaku board?
>
> Regards
> Jan
>
>
> --
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.
>
>
> ___________________________
> microblaze-uclinux mailing list
> microblaze-uclinux@itee.uq.edu.au Project Home Page :
http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@itee.uq.edu.au
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/