[microblaze-uclinux] memec v2p7 booting issue

[mcnernbm@xxxxxxxxxxxxxxxxx]

Using the auto-config method I receive
the following when I try to run the build kernel:

Calibrating delay loop... 32.97 BogoMIPS
Memory: 16MB = 16MB total
Memory: 15400KB available (601K code,
196K data, 32K init)
Dentry cache hash table entries: 2048
(order: 2, 16384 bytes)
Inode cache hash table entries: 1024
(order: 1, 8192 bytes)
Mount cache hash table entries: 512
(order: 0, 4096 bytes)
Buffer cache hash table entries: 1024
(order: 0, 4096 bytes)
Page-cache hash table entries: 4096
(order: 2, 16384 bytes)
POSIX conformance testing by UNIFIX
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer
Society NET3.039
Microblaze UARTlite serial driver version
1.00
ttyS0 at 0xffff2000 (irq = 1) is a Microblaze
UARTlite
Starting kswapd
xgpio #0 at 0xFFFF5000 mapped to 0xFFFF5000
Xilinx GPIO registered
RAMDISK driver initialized: 16 RAM disks
of 4096K size 1024 blocksize
uclinux[mtd]: RAM probe address=0x800c791c
size=0x77000
uclinux[mtd]: root filesystem index=0
VFS: Mounted root (romfs filesystem)
readonly.
Freeing init memory: 32K
release_dev: driver.table[60] not tty
for (04:40)
Warning: unable to open an initial console.
Kernel panic: No init found.  Try
passing init= option to kernel.

I am not sure what to try I have already
changed the mdm from flash to the generic rom/ram setting.
ANy help would be greatly appreciated
also atached are the .mhs and .mss files from the hardware.  I am
also using EDK 7.1.

Attachment: system.mss
Description: Binary data

Attachment: system.mhs
Description: Binary data