I also noticed in places it says the
default is username is root and password is uClinux but that still does
not work it just asks for a username and password again and again with
no luck
Brett
mcnernbm@notes.udayton.edu Sent by: owner-microblaze-uclinux@itee.uq.edu.au
04/21/2005 03:28 PM
Please respond to
microblaze-uclinux@itee.uq.edu.au
To
microblaze-uclinux@itee.uq.edu.au
cc
Subject
[microblaze-uclinux] login
issue when booting
When booting the uclinux on a memec v2p board I get the results below.
But once it hits the login part I can not login. I have tried
root as the username and pass and jsut root as used and no pass and I can
nto get it to login. Also there is the one fail listed and not sure
if that is causing me a problem or not. Also the only thing I changed
when I built the kerneal is I disable the ethernet and networking stuff
and the gpio driver and I also changed the MDM to the generic rom selection.
All other option I left alone.
zone(0): 8192 pages.ash device at locati
zone(1): 0 pages.rch for id:(00 00
zone(2): 0 pages.pe(2)rning: dev (
CPU: MICROBLAZErch for id:(00
Kernel command line:e
MBVanil
CFI: Found
Console: xmbserial on UARTLitero00 00) interleave(2) type(1)
Page-cache hash table entries: 8192 (order: 3, 32768 bytes)
POSIX conformance testing by UNIFIX
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Microblaze UARTlite serial driver version 1.00
ttyS0 at 0xffff2000 (irq = 1) is a Microblaze UARTlite
Starting kswapd
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
uclinux[mtd]: RAM probe address=0x800c58fc size=0xb2000
uclinux[mtd]: root filesystem index=0
VFS: Mounted root (romfs filesystem) readonly.
Freeing init memory: 32K
Mounting proc:
Mounting var:
Populating /var:
Running local start scripts.
Mounting /etc/config:
Populating /etc/config:
flatfsd: Nonexistent or bad flatfs (-43), creating new one...
flatfsd: Failed to write flatfs (-43): No such device
flatfsd: Created 3 configuration files (142 bytes)
Setting hostname: