Re: [microblaze-uclinux] login issue when booting

[mcnernbm@xxxxxxxxxxxxxxxxx]

Also after looking at the make file
it seems to be set as iser name root and password root and I know I tried
this.  Not sure if hyperterminal is acting weird and nto sending the
right things or what.  But I will also post another boot image tomarrow
to see if the console ouput looks normal or not.  That part that is
chopped up might have been out of the main window in hyperterminal and
once that happens who knows how it looks.  But at least I farther
then before and seem to be almost there. 
Brett

John Williams <jwilliams@itee.uq.edu.au>
Sent by: owner-microblaze-uclinux@itee.uq.edu.au

04/21/2005 06:12 PM

Please respond to
microblaze-uclinux@itee.uq.edu.au

To	microblaze-uclinux@itee.uq.edu.au
cc
Subject	Re: [microblaze-uclinux] login issue when booting

Hi Brett,

mcnernbm@notes.udayton.edu wrote:
> 
> I also noticed in places it says the default is username is root and
> password is uClinux but that still does not work it just asks for
a 
> username and password again and again with no luck

So at least you got past the romfs/init problem?  Was it just the
console issue that was fixed yesterady, or was there something else as
well?

> When booting the uclinux on a memec v2p board I get the results below.
>  But once it hits the login part I can not login.  I have
tried root as 
> the username and pass and jsut root as used and no pass and I can
nto 
> get it to login.  Also there is the one fail listed and not sure
if that 
> is causing me a problem or not.  Also the only thing I changed
when I 
> built the kerneal is I disable the ethernet and networking stuff and
the 
> gpio driver and I also changed the MDM to the generic rom selection.
>  All other option I left alone.

check vendors/Xilinx/uclinux-auto/Makefile, search for "root",
you'll 
see where the default password is set.  It should be root and root....

> zone(0): 8192 pages.ash device at locati
> zone(1): 0 pages.rch for id:(00 00
> zone(2): 0 pages.pe(2)rning: dev (

[snip]

this concerns me a bit - your console output is all chopped up and 
mangled, is this how it looks on your terminal (what terminal SW are you
using?), or is it just a problem in copying it into your email?

Regards,

John
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@itee.uq.edu.au
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/