Hi
William,
I’m not quite sure
what you are getting at here (sorry). Config.in is literally every bit
of information
that libgen can get out of the system: parameters addresses
etc. Even for peripherals that linux
has no drivers
for.
What do you mean by
generating an address range that is max? The memory bank/name of the
main memory are set in the mss file. It is possible to override the
memory size in the mss also.
It’s always a bit
trickier when the handover is to a remote site. Is your handover the
config.in file,
or a working kernel image? Have you tried running up
the kernel on the board?
Best
regards
Kris
--
----------------------------------------------------------------------------
/
/\/ Kris Chaplin
\ \ Application Engineer - Embedded
Processors
/ / Xilinx Europe
\_\/\ +44
(0)870-7356-563
From:
owner-microblaze-uclinux@itee.uq.edu.au
[mailto:owner-microblaze-uclinux@itee.uq.edu.au] On Behalf Of wlovell
Sent: 22 April 2005 18:00
To: microblaze-uclinux@itee.uq.edu.au
Subject: [microblaze-uclinux] auto-config
question
I
presume I have a setting wrong but unable to locate it. When the auto-config
tool generates the file it is pulling in all the banks of ram from the EMC IP.
This includes the unused ones. Which then generates an address range that is
max. Unfortunately the Linux programmer is half way across the country and we
were not contracted for that section of the project. Has anyone else run into
this?
William
Lovell, Senior Design Engineer
PSoC
& Xilinx Consultant
c-Link
Systems, Inc.
PO
Box
295
Waterford, ME 04088
P -
207-583-6470
F -
207-583-6247
wlovell@c-linksystems.com
www.c-linksystems.com