[microblaze-uclinux] Re: Microblaze using uclinux

[Anuroop M <anuroop.m@xxxxxxxxx>]

HI
I have followed the following procedure as per williams to generate
autoconfig.in.
1)Downloaded  auto uclinux version from the site.
2) copied BSP directory to our hardware project directory (directory
name is with new platform name.)
3)Ran 'make libs' from bsp/uclinux/src/microblaze/
4)Then it could compile successfully but found no autoconfig.in file there.,
What went wrong  ?
What  am I missing ..? 
It would be great if someone can help me on this.
Looking fwd for a quick reply from the group.

------------Anuroop




----- Original Message ----- 
From: "John Williams" <jwilliams@itee.uq.edu.au>
To: "visalakshmi" <visalakshmi@cg-coreel.com>
Cc: "Anuroop" <anuroop@cg-coreel.com>; <jithin@cg-coreel.com>
Sent: Thursday, June 02, 2005 4:05 AM
Subject: Re: Microblaze using uclinux


> Hello,
> 
> Your hardware looks ok, but you are not using the uClinux auto-config 
> BSP in the MSS file.
> 
> Download any of the auto-config hardware platforms from my website
> 
> http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
> 
> and look at the MSS file - it will show you how to use the BSP tools.
> 
> When you run libgen, it will automatically generate a correct 
> auto-config.in file, which you transfer into the platforms/XXX directory 
> on your uClinux sources.
> 
> Then, rebuild the configuration, and it should work.
> 
> Can you please direct future messages to the mailing list?
> 
> Thanks,
> 
> John
> 
>

___________________________
microblaze-uclinux mailing list
microblaze-uclinux@itee.uq.edu.au
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/