[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [microblaze-uclinux] Uclinux + ml403




ok sounds good john,  I will take the mocroblaze reference design from xilinx and attempt to use that.  I take it the ml401 reference design on your website would be a good reference point?  Also to add the connection for the interrupt controler all I need to do is modify the .mhs file by adding in the interrupt port to each device and also to the intc device?  If this is the case I will build the hardware in the next day or 2 and post the mss and mhs files.
Thanks
Brett



John Williams <jwilliams@itee.uq.edu.au>
Sent by: owner-microblaze-uclinux@itee.uq.edu.au

06/13/2005 06:36 PM

Please respond to
microblaze-uclinux@itee.uq.edu.au

To
microblaze-uclinux@itee.uq.edu.au
cc
Subject
Re: [microblaze-uclinux] Uclinux + ml403





Hi Brett,

mcnernbm@notes.udayton.edu wrote:

> I have tried to replicate the ml401 hardware for the ml403 but I can not
> get the uclinux bsp to build.  It keeps returning different errors
> everythime I try to slightly modify it.  Has anyoen gotten uclinux ontot
> eh ml403 yet?  Or does anyone have a set of steps to build the correct
> hardware for the xilinx ml403?

Assuming you have a reference design for the ML403, just tweak the MHS
so that the timer, ethernet and uartlite interrupts are connected to the
interrupt controller.  Then modify the MSS file so that the "OS" section
specificies uClinux instead of "standalone".  Use any other auto-config
MSS file as a reference.

I don't have an ML403 (yet), but have done a speculative kernel build.
It was the same as for any other board.  You can post your MHS and MSS
here if you'd like someone to take a look at it.

Cheers,

John
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@itee.uq.edu.au
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/