John here are the mhs and mss files.
AS before the hardware seem to build fine but nit sure its 100% correct.
If it is ok then I am must not be selecting the right options when
building the kernel or something
Brett
John Williams <jwilliams@itee.uq.edu.au> Sent by: owner-microblaze-uclinux@itee.uq.edu.au
06/27/2005 10:33 PM
Please respond to
microblaze-uclinux@itee.uq.edu.au
To
microblaze-uclinux@itee.uq.edu.au
cc
Subject
Re: [microblaze-uclinux]
ml403
Brett,
mcnernbm@notes.udayton.edu wrote:
> I Have gotten the hardware to work but I can not get anything work
with
> uclinux. I built a kernel and everything and then when I go
to run it I
> get nothing out. Attached is the hardware I am using any help
in
> verifying the hardware is setup correctly would be greatly appreciated.
Can you please repost just your MHS, MSS and auto-config.in files? Much
easier for a quick examination than downloading and unpacking a 3Mbyte
archive
Regards,
John
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@itee.uq.edu.au
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/