Re: [microblaze-uclinux] Memec 3sMB1500 boot problems

[Mike Kurdziel <michael.kurdziel@xxxxxxxxxxxxxxxx>]

Carr, Vincent wrote:

>David,
>
>  
>
>uClinux boots!  I turned off caching by changing the following entries
>in the MHS file:
>
>PARAMETER C_USE_ICACHE = 0
>PARAMETER C_USE_DCACHE = 0
>
>This begs a further question as to why turning off caching on the
>microblaze enabled uclinux to boot.  Is there some config on the uclinux
>side that I could have tweaked to also allow uClinux to boot.
>
>Thanks again,
>Vincent 
>
>  
>
>  
>
Vincent,
Did you get it working using the .bin or the .elf? I am also having 
problems with the Memec 3sMB1500 board and followed the same steps as 
you but mine stops here.

Freeing init memory: 44K
munmap of non-mmaped memory by process 9 (sh): 00000000
munmap of non-mmaped memory by process 9 (sh): 00000000

Any suggestions?

Thanks in advance,
Mike

___________________________
microblaze-uclinux mailing list
microblaze-uclinux@itee.uq.edu.au
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/