RE: [microblaze-uclinux] bootloader

["Eric Lynum" <elynum@xxxxxxx>]

Thanks, the zip file does contain a lot of info.  Since I have a Virtex2 pro
eval board from Avnet.  It's like I have to do a lot to get the flash up and
to load the code because it's wired differently and the prom isn't serial.  

-----Original Message-----
From: owner-microblaze-uclinux@xxxxxxxxxxxxxx
[mailto:owner-microblaze-uclinux@xxxxxxxxxxxxxx] On Behalf Of Paul Hartke
Sent: Thursday, October 20, 2005 10:44 AM
To: microblaze-uclinux@xxxxxxxxxxxxxx; Eric Lynum
Cc: microblaze-uclinux@xxxxxxxxxxxxxx
Subject: Re: [microblaze-uclinux] bootloader

Is this the Xapp you were looking at?  There is a reference design in an
accompanying zip file which should be a good place to start.

MicroBlaze Platform Flash/PROM Boot Loader and User Data Storage
http://www.xilinx.com/bvdocs/appnotes/xapp482.pdf

Quoting Eric Lynum <elynum@xxxxxxx>:
> So does anyone know the steps I must take to implement a bootloader in
> the
> xilinx platform flash.  I was looking at a xilinx app note but it didn't
> go
> over how to do it step by step.
>
> Thanks,
>
> Eric
>
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive :
http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/

___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/