Re: [microblaze-uclinux] SystemACE mount on S3MB1500 fails

[Marco Cavallini <arm.linux@xxxxxxxxxxxxxxxx>]

> Did you enable MSDOS partition in the uclinux kernel config?
> CONFIG_PARTITION_ADVANCED=y
> CONFIG_MSDOS_PARTITION=y

I completely ignored and forgotten to set such options, thank you ;-)

After doing that,
actually the problems starts earlier:

.snip.
Initializing SystemAce driver
Partition check:
 xsysacea: <3>JTAG controller couldn't read configuration from the
CompactFlash
 xsysacea1
System ACE at 0x61000000 mapped to 0x61000000, irq=2, 31744KB

I tried 3 different CFs, two hangs during boot at Partition check,
and one reaches the login prompt.

However mount command always freezed the system
# mount -t msdos /dev/xsysacea1 /mnt
[here is freezed]

Any futher hints ?
ciao

/marco
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/