RE: [microblaze-uclinux] xmdstub

[Wade.Maxfield@xxxxxxxxxxxxxxx]

    I'm continuing this thread because I'm now at another stopping point.
I'm trying to be able to debug bootstrap code and other items that will be
programming uClinux into flash and downloading and jumping to flash.

   when I run the Xilinx 8.1 XMD debugger, when interrupts are enabled, I
get

x10   <_vector_interrupt>:          brai  9012  // 0x2334
<__interrupt_handler>

  over and over and over and over..........................

   I can force it to step out of this using assembly step instructions.  I
googled microblaze uclinux, read every one of the subject in the 3 years of
the list, and also searched Xilinx's site.  I don't have an answer for this
problem.

   Does anyone have a clue on how to get it to stop going to the
_vector_interrupt and just step the source code lines?   I'm going back to
print statements for debugging, but it sure would be nice to use the
debugging tools.

thanks,
wade
***CONFIDENTIALITY NOTICE***
This communication (and any attachment) is confidential. It should only be
read by the person(s) to whom
it is addressed.  If you have received this communication in error, please
notify the sender by reply and delete this communication.
*****************************************

___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/