Thanks! I'll give it a try. -----Original Message----- From: owner-microblaze-uclinux@xxxxxxxxxxxxxx on behalf of e.stiebler Sent: Thu 10/11/2007 3:58 PM To: microblaze-uclinux@xxxxxxxxxxxxxx Subject: Re: [microblaze-uclinux] PetaLinux on XC3S1600E Digilent board Watts, Jim wrote: > I'm trying to use the Digilent Xilinx Spartan3E-1600 board with the > reference design I downloaded from the petalinux website. I've tried > the 9.1 and 8.2 versions (using the appropriate versions of Xilinx > tools) put can not meet timing. Is there a trick I'm missing? I did > try inserting input buffers on the PHY tx and rx clocks (as was done in > the Avnet uClinux port), but that didn't help. AFAIRC, I had the same problem when I was playing with the digilent s1600e. I had to increase the P&R and mapping effort levels to high. Then it worked. Cheers ___________________________ microblaze-uclinux mailing list microblaze-uclinux@xxxxxxxxxxxxxx Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/
<<winmail.dat>>