Re: [microblaze-uclinux] FS-Boot, EDK 10.1 Spartan 500ERevD

["Nathan Hillery" <nhillery1@xxxxxxxxx>]

To be sure I understand, it fails only when you use the fs-boot you
built? Your u-boot works with the pre-built fs-boot, correct?

It sounds like your fs-boot is recognizing the image in flash, so it
is able to properly read at least the first couple of bytes. You
should be able to step through with the debugger and see what happens
in more detail when it copies the image into ram and jumps into it.

On 10/11/08, Hubert Bahr <hab@xxxxxxxxx> wrote:
> Hello
>     Starting from the Petalogix reference design for the Spartan 500E
> Rev D Starter Kit I can't get to Uboot from the FS-Boot.   The pre-built
> images work fine.  The new images I built work fine with FS-boot image
> from the pre-built.  But it will not boot either U-boot in the flash or
> a new one downloaded via Kermit.  Either way it hangs after the
> FS-BOOT:   Booting image...
> response.
>
> As far as I can tell the only changes from the reference are the ones
> that XPS generated in the upgrade from 9.1.  Any suggestions as to my
> next step will be appreciated
>
> Hubert Bahr
> ___________________________
> microblaze-uclinux mailing list
> microblaze-uclinux@xxxxxxxxxxxxxx
> Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
> Mailing List Archive :
> http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/
>
>
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/