RE: [microblaze-uclinux] spartum 3a linux booting

["Deepak Yadav" <deepak.yadav@xxxxxxxxxxxxxx>]

Hi Michal,
		Please see my in-line comments.
Thanks
Deepak

-----Original Message-----
From: owner-microblaze-uclinux@xxxxxxxxxxxxxx
[mailto:owner-microblaze-uclinux@xxxxxxxxxxxxxx] On Behalf Of Michal Simek
Sent: Monday, February 02, 2009 2:47 PM
To: microblaze-uclinux@xxxxxxxxxxxxxx
Subject: Re: [microblaze-uclinux] spartum 3a linux booting

Hi Deepak,

> Hi,
> 
>     I am try to boot petalinux on spartum 3a.But nothing is seen on
> terminal.
> 
> Currently I am using XPS 10.1.In this OPB is replace with PLB.

yes.


> 
> Following Steps follows.
> 
>  
> 
> 1.Take spartum 3E-500 REVC linux kernel code.
> 
> 2.Generate Kconfig for Spartum 3A board.
> 
> 3.Copy this Kconfig in spartum 3E-500 REVC code.
> 
> 4.Build Kernel.
> 
> 5.Boot FS boot from RAM.
> 
> 6.Copy kernel image(image.bin) in ram start address by using dow command.
> 
> 7.Con at start address.
> 

Better strategy is
0. source setting.sh script
1. I hope you mean spartan3a that you use spartan3a xilinx devel board but
doesn't matter. -> setup petalogix BSP is software setting. You should use
petalinux prepare flow -> I mean your hw design in hardware/user-platforms.
2. Build your hw design
3. run petalinux-new-platform
4. go to ../../software/petalinux-dist
5. make menuconfig -> choose your board
6. make
and then load image.bin to memory with dow as you wrote above. I recommend
you
as force command line console=ttyUL0,115200(in linux menuconfig -> make
linux_menuconfig) for uartlite console.
7. setup correct baudrate on your serial terminal.

I follows from step number 0 to 7.But after this I don't see any print on
terminal of kernel booting.

So my question is for Spartum3a What should I need to chamge in Kernel(2.6).

More over is there any change needed for XPS 10.1.The Kenel which is pick
from petalinux for device Spartum-3E500 REVC is build in XPS 9.1 Which is
ported for Spartum3A.

 


8. I recommend you try after 30s or similar to try to ping your board or try
to
connect to it with telnet. (IP is set in distribution menuconfig -> make
config_menuconfig)


Regards,
Michal

> After this noting is seen on the terminal.
> 
>  
> 
> Thanks
> 
>  
> 
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive :
http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/

___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/