Hi John and Michal,
you were right with your assumptions, I copied our vendor folder to the new petalogix tree.
I deleted the vendor folder again and used:
petalinux-new-platform -v nanotronic -p s3a-starter -k 2.6
afterwards I updated the config.arch link in the petlinux-dist folder as it was broken.
I run make menuconfig and make again and u-boot was build successfully (I expected a failure due to I did not undo the changes).
Regarding cpuinfo in /proc:
When using the obsolete parameter: PARAMETER CORE_CLOCK_FREQ_HZ = 66666667 in the mss file
it is correct.
I am fine with that, just wanted to let you know.
From: owner-microblaze-uclinux@xxxxxxxxxxxxxx on behalf of Michal Simek
Sent: Sun 3/22/2009 10:14 AM
Subject: Re: [microblaze-uclinux] A few small things which might be bugs
Hi John, Marco
>> #ifdef CONFIG_UARTLITE
>> #ifdef CONFIG_SERIAL_UARTLITE
> The petalinux BSP generator changed slightly a few months ago, in its
> export of this CONFIG_UARTLITE / CONFIG_UART16550, so that u-boot (and
> the linux system) could use either uartlite or uart16550 as the
> I think what you actually need to do is regenerate your Kconfig.auto
> and auto-config.h, using the new BSP tools that would have been
> installed when you pulled from the SVN tree.
> I'm guessing maybe you used your old Kconfig.auto from an earlier release?
> Michal did this change - @Michal can you please confirm my suggestion
> is correct?
Yes. This change is there because we support uartlite or uart16550 console.
As John wrote - run petalinux bsp again in hw project and update your
Kconfig.auto and I believe that will work.
Michal Simek, Ing. (M.Eng)
PetaLogix - Linux Solutions for a Reconfigurable World
w: www.petalogix.com p: +61-7-30090663,+42-0-721842854 f: +61-7-30090663
microblaze-uclinux mailing list
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/