Re: [microblaze-uclinux] hanging at migration from petalinux v0.30 to v0.40

[Giulio Mazzoleni <giulio.mazzoleni@xxxxxxxxxxxxxxxxxxxxxxx>]

Hi Sergi,
I encountered the same issue, too, even if not specific to v0.40.
I resolved by using CONFIG_LARGE_ALLOC: "Allow allocating large blocks 
(> 1MB) of memory" in kernel configuration under "Processor type and 
features".
It could be because of increased size of busybox executable. Maybe it 
could be possible to compress it. It has already been discussed on this 
mailing list.
Hope it helps to resolve your issue.
Best regards,
Giulio

Sergi Gómez ha scritto:
> Hello,
> I’m just a new user for microblaze, just a few weeks experienced. I 
> successfully set up a Spartan2DSP1800 board with Petalinux v0.30. But 
> due to Xilinx_IIC driver problems, I had to migrate to petalinux v0.40 
> release.
> I configured the v0.40 kernel exactly with the same features as for 
> v0.30, checked line by line during the kernel configuration, but when 
> starting up, it gets hang after showing: “Unable to allocate RAM for 
> process text/data, errno 12”

___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/