Re: [microblaze-uclinux] u-boot error 'end address not on sector boundary' on ml403

[Aleksandar SUTIC <asutic@xxxxxxxxx>]

	The UART is really mapped at the given address. This is what I read in 
XPS. I run petalinux-copy-autoconfig, so there shouldn't be any problem.

	No boot command is specified via 'make menuconfig'. This filed is left 
empty. Since I'm not really an expert, I'm not sure what I should put 
here...

	I'll re-check my procedure, but I won't be able to do it before Monday 
:-(. If you have any other idea in the meanwhile, don't hesitate to 
share it with me.

	Aleks
	

Nicolas Herve wrote:
> I had this problem too,
> mmmh,
> What is your boot command ? The one passed to the linux kernel ?
> It should not have any console=... argument.
>
> 2009/6/5 Aleksandar Sutic <asutic@xxxxxxxxx>:
> > I know that this is a typical issue that a lot of newcomers face with
> > PetaLinux. Other people reported it also, but I'm still not able to resolve
> > it. Typically, it may come from badly mapped console (early printk), but it
> > seems that for it is not the case.
>
> mmmh, your CONFIG_SERIAL_UARTLITE and CONFIG_SERIAL_UARTLITE_CONSOLE
> are set as they should.
>
> Is your UARTLITE really map on address 0x84000000 ?
> > CONFIG_XILINX_UARTLITE_0_BASEADDR=0x84000000
>
> I don't know if a new configuration with XPS cannot change this.
> Make sure you run `petalinux-copy-autoconfig` from your XPS project dir.
>
> No more idea.
>
> Hopping it helps
> Nicolas
> ___________________________
> microblaze-uclinux mailing list
> microblaze-uclinux@xxxxxxxxxxxxxx
> Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
> Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/