[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [microblaze-uclinux] Changing from S3E500 to 1600

To: microblaze-uclinux@xxxxxxxxxxxxxx
Subject: Re: [microblaze-uclinux] Changing from S3E500 to 1600
From: Paulo Ferreira <paf@xxxxxxxx>
Date: Thu, 27 Aug 2009 16:32:22 +0100
In-reply-to: <1251385432.6613.15.camel@xxxxxxxxxxxxxxxxxx>
References: <4D962476-88F6-4C44-819D-F40ED824A625@xxxxxxxx> <1251385432.6613.15.camel@xxxxxxxxxxxxxxxxxx>
Reply-to: microblaze-uclinux@xxxxxxxxxxxxxx
Sender: owner-microblaze-uclinux@xxxxxxxxxxxxxxxxxxxx


On 2009/08/27, at 16:03, Torin Ford wrote:

Just a guess here, but I'm assuming you went through the BSB to setup
your hardware platform?  If so, during that process you had the option
to add/remove the buttons.  It appears that you chose to remove them.

Torin Ford
Software Engineer
nextScan, Inc.


Thanks for the guess, but no.

I just compiled the reference design, just like it was when Idownloaded it a couple of hours ago.



But I will check BSB to "add the buttons back".


My regards

Paulo Ferreira

___________________________

microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/

References:
- [microblaze-uclinux] Changing from S3E500 to 1600
  - From: Paulo Ferreira
- Re: [microblaze-uclinux] Changing from S3E500 to 1600
  - From: Torin Ford

Prev by Date: Re: [microblaze-uclinux] Changing from S3E500 to 1600
Next by Date: Re: [microblaze-uclinux] Boot Problem
Previous by thread: Re: [microblaze-uclinux] Changing from S3E500 to 1600
Index(es):
- Date
- Thread