Re: [microblaze-uclinux] Boot Problem

[hoefle marco <marco.hoefle@xxxxxxxxxxxxx>]

On Wed, 2009-08-26 at 13:08 -0600, Torin Ford wrote:
> I have a boot problem.  I remember seeing someone else mail about it
> recently but can't seem to find the messages in the archive.  The
> problem is this - Boot up the system, a first stage boot loader loads
> u-boot into RAM, then jumps to it.  u-boot runs, and sees that there is
> an autoboot image available, so it loads that image and jumps to it.
> The image is a linux kernel image and outputs:
> 
> #### klimit 8c1fa000 ####
> Moving 0x000e4000 bytes from 0x8c1e208c to 0x8c1f98f0
> New klimit: 0x8c2de000
> 
> At this point, it appears to reset, as the first stage boot loader runs.
> Could the flash partition ordering and the absence of the "config" and
> "spare" partitions cause this?

Hello Torin,
I have the same problem as you. I thought it might be related to the mmu
configuration. Did you solve it in the meanwhile?
Thanks,
Marco

___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/