[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [microblaze-uclinux] fsboot problem
--
Martin Thompson CEng MIET
TRW Conekt, Stratford Road, Solihull, B90 4GW. UK
+44 (0)121-627-3569 : martin.j.thompson@xxxxxxx
http://www.conekt.net/
>>> On 25 September 2009 at 20:22, in message
<233404F7FBE34D5A9FF881BD094141A6@xxxxxxxxxxxxx>, Orlando Landrove
Gámez
<landrove@xxxxxxxxxx> wrote:
> Thanks Martin for your care. Let me tell you somethig....
>
> In EDK (nothing about petalinux), I tested the example software
> "Test_memory" that allows me test serial port (DTE or DCE). Well,
using DTE
> port (with my cable to may CPU serial port), with hyperterminal there
is
> nothing on the console. But it does using Spartan 3E DCE.....So, I
saw words
> in my hyperterminal using DCE... So, a question....
>
OK, that's good news :) Are you using a different EDK setup between
the test memory and the fsboot build?
> -Do you think it could be the same for my Fsboot project ???...I
think it
> is....If so, I must to change my output DTE for DCE in EDK reference
> project.....or cables TX and RX pins.
If it's not the same EDK setup, check in EDK to see which port
STDIN/STDOUT are directed to (in the software settings) ... compare it
with your memory test setup.
Cheers,
Martin
Conekt is a trading division of TRW Limited
Registered in England, No. 872948
Registered Office Address: Stratford Road, Solihull B90 4AX
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/