Re: [partial-reconfig] Problem with Bus macro in Virtex-II

[John Williams <jwilliams@xxxxxxxxxxxxxx>]

Hi John

jedward@lme.usp.br wrote:
> I am using ISE6.2i, and Virtex-II X2CV1000. When i use:
> 
>  "ngdbuild -modular initial top.ngc"
> 
> The tool reports some errors with the bus macro, like this:
> 
> Reading component libraries for design expansion...
> Loading device for application ngdbuild from file '2v1000.nph' in environment
> C:/Xilinx.
> Loading macro from file "E:\John\exemplo\top\inicial/bm_4b_v2.nmc".
> ERROR:NgdBuild:76 - File "E:\John\exemplo\top\inicial/bm_4b_v2.nmc" cannot
> be merged into block "BM_reconfig_1_to_capture_result"
> (TYPE="bm_4b_v2")because one or more pins on the block, including pin
> "LI<3>", were not found in the file.  

There is a Xilinx answer record on this one:

http://support.xilinx.com/xlnx/xil_ans_display.jsp?iLanguageID=1&iCountryID=1&getPagePath=14848

Basically it's to do with signal vectors using the '< >' vs '( )' 
synatx.  If I remember rightly, I just hand edited the bus macro file in 
hexedit, and changed the characters appropriately.

Cheers,

John
___________________________
partial-reconfig mailing list
partial-reconfig@itee.uq.edu.au
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/partial-reconfig/