Re: [partial-reconfig] ISE_7_1_01_Not_Reading_XAPP290_Bus_macros

[<bartosr@xxxxxxxxxx>]

Hi,

I am working on partial dynamic reconfiguration, too. I had some problems

with ISE 6.3i. Therefore I waited for ISE7.1, but when I installed it, I read

the following note in instalation guide :-(

 

Partial Reconfiguration

The following issue pertains to Partial Reconfiguration:

Title: ISE 7.1i Partial Reconfiguration - Partial Reconfiguration support requires an ISE

7.1i Service Pack.

Description: Software support for Partial Reconfiguration is not enabled by default in

the ISE 7.1i release. Software support for partial reconfiguration is planned for an ISE

7.1i Service Pack. For more information, please see Answer Record 20494.

Reference: Xilinx Answer Record #20494, or

http://www.xilinx.com/xlnx/xil_ans_display.jsp?getPagePath=20494

 

So, I downloaded ISE7.1 Service Pack 1, but in SP is nothing new about

PR.

:-(

 

When I tried create my own BusMacro in FPGAEditor 7.1, it always crashed.

:-(

 

Now, I am back in ISE6.3 SP2.

 

Regards,

Roman Bartosinski

______________________________________________________________
> Od: Phillip Jones <phjones@arl.wustl.edu>
> Komu: partial-reconfig@itee.uq.edu.au
> Datum: Wed, 30 Mar 2005 22:37:42 -0600 (CST)
> Předmět: [partial-reconfig] ISE_7_1_01_Not_Reading_XAPP290_Bus_macros
>
> I am working on partial dynamic reconfiguration of VirtexE FPGAs. I have
> recently upgraded software to ISE 7.1i. I am having the following
> problem:
> 
> - The bus macros supplied by the XAPP290 example do not appear to be read
> by the new tools correctly.
> 
> a.) FPGA Editor will not open bm_4b_ve.nmc bus macro
> 
> b.) During the map stage of a module I get the following error message:
> 
> FATAL_ERROR:Pack:pkibatranslate.c:1893:1.74.6.13 - Unexpected failure
> during hard macro processing. Xdm_Excepti!
 on::DuplicateObjectFound
> object='bm_4be' (XDM_DESIGN), parent='rad_liquid' (XDM_DESIGN_MGR) \n
> Process will terminate.
> 
> I have installed service pack 1 for ISE 7.1, also when I run a tool such
> as xdl -ncd2xdl the tool gives a message that it is converting the 6.x
> version of the bus macro to an updated version.
> 
> Any assistance in tracking down the cause of this behavior would be much
> appreciated.
> 
> Thank you.
> 
> Phillip.
> ___________________________
> partial-reconfig mailing list
> partial-reconfig@itee.uq.edu.au
> Mailing List Archive : http://www.itee.uq.edu.au/~listarch/partial-reconfig/