Re: [partial-reconfig] Active Reconfiguration

["Karel Bruneel" <karel.bruneel@xxxxxxxxxx>]

Hi,

I've had a simular problem. In my case it seemed that bitgen 
created corrupt partial bitstreams. The BRAM-interconnect 
frames are not present in the bitstreams. To solve this I
wrote a program that extracts a partial bitstream from a
full bitstream.

regards,
Karel

>----- Oorspronkelijk bericht -----
>Van: Pittman, Richard N [mailto:rnpittman@neo.tamu.edu]
>Verzonden: maandag, juni 13, 2005 06:43 PM
>Aan: partial-reconfig@itee.uq.edu.au
>Onderwerp: [partial-reconfig] Active Reconfiguration
>
>
>I really need some help.  I solved my previous routing problem adding some 
>addtitional bus macros and loc them in place to help route the signals but 
>now I have a new problem.
>
>I have generated partial bitmaps of my design.  I have created full bitmaps 
>of each configuration to verify that they work and they do.  But when I use 
>the partial bitmaps to actively reconfigure from one configuration to 
>another, the system does not function properly even though it did when I 
>used the full bit map of the same configuration.  Please help.  I am not 
>really sure where to start looking for the problem.
>
>Neil
>
>___________________________
>partial-reconfig mailing list
>partial-reconfig@itee.uq.edu.au
>Mailing List Archive : http://www.itee.uq.edu.au/~listarch/partial-reconfig/
>
>


___________________________
partial-reconfig mailing list
partial-reconfig@itee.uq.edu.au
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/partial-reconfig/