Re: [partial-reconfig] ICAP & the Virtex-II Multimedia board

["Remy Eskinazi" <res@xxxxxxxxxxx>]

Hi Guhaiyun

I think that the ICAP module is fixed and it's not possible to change the 
phisycal position. The system ace can be disable in order have not 
interference in the iCAP module.

Remy Eskinazi

----- Original Message ----- 
From: "guhaiyun" <guhaiyun@nju.edu.cn>
To: <partial-reconfig@itee.uq.edu.au>
Sent: Thursday, June 23, 2005 10:27 PM
Subject: [partial-reconfig] ICAP & the Virtex-II Multimedia board


> hi,everyone,
>
>      I want to use ICAP on the Virtex-II Multimedia Development 
> Board(XC2V2000), but the
> sysace pins on this board are located on the lower right corner of of the 
> device. Is it necessary to locate the ICAP to the lowest right corner of 
> the array? How can I change the location of ICAP?
>      Has anyone tryed a simular thing?
>      Thanks a lot!
>
>
>                    echo
> 　　　　　　　　guhaiyun@nju.edu.cn
> 　　　　　　　　　　2005-06-24
>
>
>
> ___________________________
> partial-reconfig mailing list
> partial-reconfig@itee.uq.edu.au
> Mailing List Archive : 
> http://www.itee.uq.edu.au/~listarch/partial-reconfig/
> 


___________________________
partial-reconfig mailing list
partial-reconfig@itee.uq.edu.au
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/partial-reconfig/