Re: [partial-reconfig] Reg uclinux/microblaze and partial reconf.

["Lakshmi Narasimhan. S" <sulakshm@xxxxxxxxxxxxxxxxxxxx>]

Hello John,
That was nice and fast. Thanks I am on to it.

OTOH, I also found that the ml310 board supports a 8KB serial eeprom
on IIC bus. So probably this can be used for startup!!!
Few questions in this regard, if anyone happens to know...

1) How do you program the eeprom in the first place with linux?
2) Is 8KB enough for a linux image? I see zImage compressed is around
   1MB!!!

Does anyone have experience using EEPROMs for (linux) startup, please
advise as to how the procedure is to be setup!

Thanks a tonne!
LN




On Mon, 15 Aug 2005, John Williams wrote:

> Hi Lakshmi,
>
> Lakshmi Narasimhan. S wrote:
>
> > But currently I am way behind this. I have EDK 6.3 and I do not
> > have an option to build uclinux under software settings for
> > microblaze. So, is there anyway that one could build a uclinux
> > for microblaze with EDK 6.3 version?
>
> Download and install the uClinux support files from the website (uClinux
> BSP package)
>
> http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux/Downloads/platforms.html
>
> Then, uClinux becomes one of the supported software settings in EDK.
> One of our students, Jason Wu, recently wrote a nice step-by-step
> document descripting the process of building a MicroBlaze/uClinux system
> from scratch.  You can find it here:
>
> http://www.itee.uq.edu.au/~wu/downloads/uClinux_ready_Microblaze_design.pdf
>
> It targets the ML401 board, but the principles apply to all
> BSB-supported hardware.
>
> Regards,
>
> John
> ___________________________
> partial-reconfig mailing list
> partial-reconfig@itee.uq.edu.au
> Mailing List Archive : http://www.itee.uq.edu.au/~listarch/partial-reconfig/
>
___________________________
partial-reconfig mailing list
partial-reconfig@itee.uq.edu.au
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/partial-reconfig/