Re: [partial-reconfig] Error in ISE6.3 PAR

[yilu@xxxxxxxxxxxxxx]

Just find some ideas from a previous thread
"http://www.itee.uq.edu.au/~listarch/partial-reconfig/archive/2004/10/msg00007.html";
Just Unplaced the relative components and unroutted all global signals in the
pims. Then do the assemble stage, now everything looks ok.




Quoting yilu@itee.uq.edu.au:

> Hi, all
>
> There is an error when I use par in the assemble stage. I am now using ISE6.3
> with service pack2. Could anyone give me some advices?
>
> Thank you
>
> luyi
>
> Error message:
> **************************************************************
> Phase 3: 2 unrouted;       REAL time: 4 mins 52 secs
>
> Phase 4: 2 unrouted; (0)      REAL time: 4 mins 53 secs
>
> Phase 5: 2 unrouted; (0)      REAL time: 4 mins 53 secs
>
> Phase 6: 2 unrouted; (0)      REAL time: 4 mins 54 secs
>
> Phase 7: 0 unrouted; (0)      REAL time: 4 mins 56 secs
>
> FATAL_ERROR:Ncd:basncsignal.c:283:1.39.8.2 - Could not find a bel for a
> signal
>    on pin F3 of comp mb_system/dlmb_LMB_Ready.  Its current programmed state
> is
>    : YUSED:0 XUSED:0 DYMUX:1 F:#LUT:D=((A2*~A4)+A1) FXMUX:F SYNC_ATTR:ASYNC
>    SRFFMUX:0 FFY_SR_ATTR:SRLOW FFY:#FF GYMUX:G FFY_INIT_ATTR:INIT0
>    G:#LUT:D=(~A3*((A1*~A4)+A2)) CEINV:CE CLKINV:CLK SRINV:SR   Process will
>    terminate.  To resolve this error, please consult the Answers Database and
>    other online resources at http://support.xilinx.com. If you need further
>    assistance, please open a Webcase by clicking on the "WebCase" link at
>    http://support.xilinx.com
>
>
>
> ___________________________
> partial-reconfig mailing list
> partial-reconfig@itee.uq.edu.au
> Mailing List Archive : http://www.itee.uq.edu.au/~listarch/partial-reconfig/
>



___________________________
partial-reconfig mailing list
partial-reconfig@itee.uq.edu.au
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/partial-reconfig/