Re: [partial-reconfig] 'PAR' halted during 'guide file processing' in 'Assemble' stage

["Hagari Pacacco" <pasacco@xxxxxxxxx>]

Hi,

 

"par.exe" crash is not appeared in ISE 6.3.02i. Thankyou.

 

One weird thing is that

 

During "PAR", in ISE 6.3.02i,  following messages are appeared.

-------------------------------------------------------------------------------------------------------------------------------

ERROR:DesignRules:579 - Netcheck: The signal U_RN/R0_Buf_local_buf_6_6 was found to be routed with nodes in two route area.  This is not permitted for modules in partial reconfiguration mode.

ERROR:DesignRules:579 - Netcheck: The signal GLOBAL_LOGIC1_4 was found to be
routed with nodes in two route area.  This is not permitted for Modules in
partial reconfiguration mode.

-----------------------------------------------------------------------------------------------------------------------

My reference design  http://elektronica.ehb.be/reco/PartialTutorial.htm also generates similar messages.

Interesting thing is that

If I ignore the "Netcheck" error message, it seems that whole flow is okay, though I did not tested after downloading into the board.

(The board with platform CABLE USB, which requires ISE 6.3.03i or above --: )

 

Moreover, the error messages above can not be seen in "*.PAR" file.
 

For now, i am ignoring the error messages above.

 

Thanks

 

On 3/6/06, jedward@xxxxxxxxxx <jedward@xxxxxxxxxx> wrote:

Hi,

I had this problem too. Try to use "ISE 6.3.02i", when i did that my work
finished the modular design completely.
Regards.

JOHN ESQUIAGOLA