Re: [partial-reconfig] icap of Virtex-II Pro

[Philipp Reinkemeier <partial-reconfig@xxxxxxxxxxxx>]

Hi

I have a few questions too. I plan using the ICAP via dedicated logic
and not from a MicroBlaze or PowerPC. I already read a few Application
notes about timing behaviour of ICAP. My questions refer to your answer
on the previous post (see below).

Gyorgy Horvath wrote:
> - Did not try to program the device until you successfuly
>  read back at least the Xilinx Device ID, and the status register.
How can i read back the status register or Device ID from ICAP.

> - Always sync-up before try
I don't know what you meen by "sync-up". Sync with what? Could you
explain this?

> - Always issue a DESYNC command when you finished
With the term "DESYNC" i am also not familiar.



Regards
Philipp
___________________________
partial-reconfig mailing list
partial-reconfig@xxxxxxxxxxxxxx
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/partial-reconfig/