Re: [partial-reconfig] icap of Virtex-II Pro

[Gyorgy Horvath <horvaath@xxxxxxxxxxxxxxxxx>]

Hi,

UG071 Page 99 shows how the things are going in case of Virtex4.
It's worked for me.
In case of Virtex II it should work too.
I am unsure about "Desync command" support on VirtexII.
Other steps are supported since the plain old Virtex devices (READ 
XAPP151 too).

Good luck,
Gyuri

Philipp Reinkemeier wrote:
> Hi
>
> I have a few questions too. I plan using the ICAP via dedicated logic
> and not from a MicroBlaze or PowerPC. I already read a few Application
> notes about timing behaviour of ICAP. My questions refer to your answer
> on the previous post (see below).
>
> Gyorgy Horvath wrote:
>   
> > - Did not try to program the device until you successfuly
> >  read back at least the Xilinx Device ID, and the status register.
> >     
> How can i read back the status register or Device ID from ICAP.
>
>   
> > - Always sync-up before try
> >     
> I don't know what you meen by "sync-up". Sync with what? Could you
> explain this?
>
>   
> > - Always issue a DESYNC command when you finished
> >     
> With the term "DESYNC" i am also not familiar.
>
>
>
> Regards
> Philipp
> ___________________________
> partial-reconfig mailing list
> partial-reconfig@xxxxxxxxxxxxxx
> Mailing List Archive : http://www.itee.uq.edu.au/~listarch/partial-reconfig/
>   

___________________________
partial-reconfig mailing list
partial-reconfig@xxxxxxxxxxxxxx
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/partial-reconfig/