[partial-reconfig] Final Stage on Module-Based Partial Reconfig

["Dani Rguez" <rodherdan@xxxxxxxxxxx>]

 Hi,

 I´m trying to run the Module-Based flow for Partial Reconfiguration as 
explained in XAPP290.pdf.

 I followed all the indications step by step and after some problems I got 
to the Final Assembly Stage. But there, I have some unbelievable problem: 
PAR takes the Bus-Macro out!! Bitgen fails in the DRC, finding a lot of 
unplaced components and completely unrouted nets, all of them part of the 
Bus-Macro and when I looked back I found using the  FPGA Editor that the 
Bus-Macro wasn´t in the last .ncd; there are both sides (the fixed side and 
the reconfigurable) but not the intermediate Bus-Macro.

 Does anyone have this problem?

 I give more information (:-D : In the Active Module Phase, I used the 
Bus-Macro in all compilations with each module, because I think it must be 
said where to route the signals. That´s why in the Final Assembly Phase both 
sides (the 2 .ncd it takes for assembling) have in common the bus-macro.

 Could it be that the problem?? I´m really lost. If anyone has a clue it 
will be welcome.

 Thank you,

 Dani


___________________________
partial-reconfig mailing list
partial-reconfig@xxxxxxxxxxxxxx
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/partial-reconfig/