Re: [partial-reconfig] About the ICAP for V4

[Lu Yi <yilu@xxxxxxxxxxxxxxxxxxxxx>]

Hello, all

Thank you all very much for your reply, I will add the old version of
OPB_ICAP or use the higher version EDK. Hoping to get your ideas later
when I goes further.

Thank you all,
luyi

> Hi,
> I'm also working on partial reconfiguration for virtex 4. Maybe you have
> an
> old version of hwicap and its drivers. You should use ise+edk 9.1 with
> service pack 2. However an engineer of Xilinx support send me the most
> recent version of icap, that support virtex 4. If you want, I can send it
> to
> you.
>
> Paolo Furia
>
> 2008/6/4 Lu Yi <yilu@xxxxxxxxxxxxxxxxxxxxx>:
>
>> Hi, all
>>
>> I am using EDK 8.2 with service pack 1 to build a PPC system used for a
>> partial reconfiguration system. I am using Xilinx ML410 board containing
>> a
>> V4FX60. However, in the EDK project, I can not find the ICAP module, I
>> checked the OPB_ICAP in the "EDK/hw" folder, the OPB_ICAP components
>> there
>> only support V2/V2P. Could anyone give some hints where I can find the
>> proper ICAP component for the V4 FPGA?
>>
>> Thank you!
>>
>> luyi
>> ___________________________
>> partial-reconfig mailing list
>> partial-reconfig@xxxxxxxxxxxxxx
>> Mailing List Archive :
>> http://www.itee.uq.edu.au/~listarch/partial-reconfig/<http://www.itee.uq.edu.au/%7Elistarch/partial-reconfig/>
>>
>

___________________________
partial-reconfig mailing list
partial-reconfig@xxxxxxxxxxxxxx
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/partial-reconfig/