Re: [partial-reconfig] Problem on HwICAP

[Lu Yi <yilu@xxxxxxxxxxxxxxxxxxxxx>]

Hi,

Which EDK version are you using and which version of HWICAP? Did you run
the hwicap_init_test() function, what was the output info?

regards,
luyi

> Dear All,
>
> I am trying to perform a partial reconfiguration on a Virtex 4 (ML402)
> using
> Microblaze and HwICAP.
>
> After initializing without errors the HwICAP, I am trying to read the
> partial bitstream from the Compact Flash using XHwICAP_CF2ICap function
> but
> it does not work since the program on the Microblaze freezes and the ERROR
> led on the board is switched on. It seems that the XHwICAP_CF2ICap
> function
> sticks when accessing the file through the function SYSACE_fopen.
>
> I tried to create again the partial bitstream but the problem persists and
> I
> also tested the bitstreams programming the device through JTAG and it
> works
> fine.
>
> ADDITIONAL INFORMATION: I am loading the full design from the compact
> flash,
> so the configuration bits are configured to 111. The full bitstream is
> loaded without any problem.
>
> Thank you
>
> Guido
>

___________________________
partial-reconfig mailing list
partial-reconfig@xxxxxxxxxxxxxx
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/partial-reconfig/