I use 1.10.a, as I've seen it's the same, it supports virtex4 and 5. Even if I include the 1.00.b in the apposite folder in my EDK installation folder, EDK show me only the 1.10.a.
For the driver I use 1.00.c.
Regards
Paolo Furia
2008/9/4 Lu Yi
<yilu@xxxxxxxxxxxxxxxxxxxxx>
Hi,
Do you use the ICAP module 1.00.b?
R.
luyi
> Dear All,
>
> I am trying to perform a partial reconfiguration on a Virtex 4 (ML402)
> using
> Microblaze and HwICAP. I'm using ISE+EDK 9.1.02 with EAPR10.
>
> After initializing without errors the HwICAP, I am trying to read the
> partial bitstream from the Compact Flash using XHwICAP_CF2ICap function
> but
> it does not work since the program on the Microblaze freezes and the ERROR
> led on the board is switched on. It seems that the XHwICAP_CF2ICap
> function
> sticks when accessing the file through the function SYSACE_fopen.
>
> I tried to create again the partial bitstream but the problem persists and
> I
> also tested the bitstreams programming the device through JTAG and it
> works
> fine.
>
>
> ADDITIONAL INFORMATION: I am loading the full design from the compact
> flash,
> so the configuration bits are configured to 111. The full bitstream is
> loaded without any problem.
>
> I run the hwicap_init_test( ) function and the output was:
>
>
> ICAP Base Addr: 40200000
> -- Reading ICAP Status
>
> Status: 1
> HWICAP Status Register:
> cfgerr_n: 0
> dalign: 0
> rip: 0
> in_abort_n: 0
> Always 1: 0
> Always 1: 0
> Always 1: 0
> Always 1: 0
> Done: 1
> -- Reading Device IDCODE through ICAP:
> Creating cmd bitstream...
> Sending cmd bitstream to ICAP...
> Reading from ICAP...
> Device IDCODE is: 0
> -- Reading Device IDCODE through ICAP:
> Creating cmd bitstream...
> Sending cmd bitstream to ICAP...
> Reading from ICAP...
> Device IDCODE is: 42088093
>
>
>
> But if I run the test again this was the result:
>
> -- ICAP Base Addr: 40200000
> Device is already initialized.-- ICAP Base Addr: 40200000
> -- Reading ICAP Status
>
> Status: 447
> HWICAP Status Register:
> cfgerr_n: 1
> dalign: 1
> rip: 0
> in_abort_n: 1
> Always 1: 1
> Always 1: 1
> Always 1: 1
> Always 1: 1
> Done: 1
> -- Reading Device IDCODE through ICAP:
> Creating cmd bitstream...
> Sending cmd bitstream to ICAP...
> Reading from ICAP...
> Device IDCODE is: 42088093
> -- Reading Device IDCODE through ICAP:
> Creating cmd bitstream...
> Sending cmd bitstream to ICAP...
> Reading from ICAP...
> Device IDCODE is: 42088093
>
>
> I'd appreciate any help.
>
> Thank you
>
>
> Paolo Furia
>
partial-reconfig mailing list
partial-reconfig@xxxxxxxxxxxxxx
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/partial-reconfig/