Hi Gael,
From Xilinx early access PR8 (9.2 sp4)
Q.10 Is Virtex-5 Supported for PR designs?
A.10 Virtex-5 is available in the tools for PR designs but is not a fully
supported device. There are software issues that can not be resolved in ISE
9.2i that the EA PR tools are build on.
Regards,
Mati Nahshon
Electronics Engineer,
Consultant.
____________________________
Cell:
+972-54-7647107
E-Mail: nahshon.mati@xxxxxxxxx
____________________________
From: owner-partial-reconfig@xxxxxxxxxxxxxx [mailto:owner-partial-reconfig@xxxxxxxxxxxxxx] On Behalf Of Ga?l ABGRALL
Sent: Monday, September 08, 2008
3:22 PM
To: partial-reconfig@xxxxxxxxxxxxxx
Subject: [partial-reconfig]
Partial reconfiguration with ML507
Hi,
I'm
a PhD student at the ENSIETA (Ecole Nationale Supérieure d'Ingénieurs des
Etudes et Techniques d'Armement) in BREST
(FRANCE) and we've just bought a ML507 with a Virtex 5 FX70 inside. With this
board, we would like implementing partial reconfiguration.
Previously
we worked on a ML403 with the 9.1 version of ISE and EDK but the ML507 seems to
be undeclared in this version. I would like to know if someone knows which
tools version can I use to implement partial reconfiguration on the ML507.
Regards,
Gael
ABGRALL
--------------------------------------------------------
Gael ABGRALL
Doctorant - PhD Student
Laboratoire DTN / CSE
ENSIETA
2 rue François Verny
29806 Brest
cedex 9
E-mail : gael.abgrall@xxxxxxxxxx