[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [partial-reconfig] Partial reconfiguration with ML507




Hi,

I have asked Xilinx for this and the answer might interest some of yours.

-----
The current version of PR tools supported is ISE 9.2.4.  Since ML507 is not supported, unfortunately it can not be used for PR.  There is no plan to do PR under 10.1.  There will be some controlled/limited support in ISE 11.1 and with widely available access in ISE 12.1 (at least that is the roadmap). 
 
So short answer is ML507 can not be used for PR in near future.
-----

For using ML506 with ISE 9.1, I had to copy manually some files in the Xilinx installation folder, may be the same thing is possible to include the ML507 in ISE 9.2.

Is anyone have an idea on it ?

Regards.

Gael ABGRALL

--------------------------------------------------------

Gael ABGRALL
Doctorant - PhD Student
Laboratoire DTN / CSE
ENSIETA
2 rue François Verny
29806 Brest cedex 9

E-mail : gael.abgrall@xxxxxxxxxx



"Mati Nahshon" <mati.nahshon@xxxxxxxxx>
Envoyé par : owner-partial-reconfig@xxxxxxxxxxxxxx

09/09/2008 08:45

Veuillez répondre à
partial-reconfig@xxxxxxxxxxxxxx

A
<partial-reconfig@xxxxxxxxxxxxxx>
cc
Objet
RE: [partial-reconfig] Partial reconfiguration with ML507





Hi Gael,
 
From Xilinx early access PR8 (9.2 sp4)
 
Q.10 Is Virtex-5 Supported for PR designs?
A.10 Virtex-5 is available in the tools for PR designs but is not a fully supported device. There are software issues that can not be resolved in ISE 9.2i that the EA PR tools are build on.

 
Regards,
 
Mati Nahshon
Electronics Engineer,
Consultant.

____________________________
Cell:     +972-54-7647107
E-Mail:
nahshon.mati@xxxxxxxxx
____________________________



From: owner-partial-reconfig@xxxxxxxxxxxxxx [mailto:owner-partial-reconfig@xxxxxxxxxxxxxx] On Behalf Of Ga?l ABGRALL
Sent:
Monday, September 08, 2008 3:22 PM
To:
partial-reconfig@xxxxxxxxxxxxxx
Subject:
[partial-reconfig] Partial reconfiguration with ML507

 

Hi,


I'm a PhD student at the ENSIETA (Ecole Nationale Supérieure d'Ingénieurs des Etudes et Techniques d'Armement) in BREST (FRANCE) and we've just bought a ML507 with a Virtex 5 FX70 inside. With this board, we would like implementing partial reconfiguration.


Previously we worked on a ML403 with the 9.1 version of ISE and EDK but the ML507 seems to be undeclared in this version. I would like to know if someone knows which tools version can I use to implement partial reconfiguration on the ML507.


Regards,


Gael ABGRALL

--------------------------------------------------------

Gael ABGRALL
Doctorant - PhD Student
Laboratoire DTN / CSE
ENSIETA
2 rue François Verny
29806 Brest cedex 9

E-mail : gael.abgrall@xxxxxxxxxx